Wet underfloor heating runs warm water from your boiler through pipe loops under the floor, turning the whole floor into a low-temperature radiator. It suits kitchens, extensions, bathrooms and open-plan ground floors where wall space is short, and it works with a gas combi or system boiler through a mixing valve and manifold.
We design the pipe loops for each room from its heat loss, install the manifold, pump and mixing valve, lay the pipe in screed, on an overlay board or between joists depending on the floor, pressure test it before the floor goes down, connect it to the boiler and commission and balance each loop. Room thermostats and zone controls let you run it separately from the radiators upstairs.
We have installed underfloor heating across Essex alongside the boilers and radiators it connects to, so the whole system is designed by one firm. Gas Safe registered (925538), family run, and quoted after a free survey.
What is included
- Design of pipe loops for each room
- Manifold, pump and mixing valve
- Connection to your existing or new boiler
- Zone controls and room thermostats
- Screed, overlay or joisted floor systems
- Pressure testing before the floor goes down
- Commissioning and balancing of each loop
- Advice on floor coverings and insulation
How it works
- Survey the rooms, floor build-up and boiler
- Design the loops and zones and quote in writing
- Install the manifold and lay the pipework
- Pressure test before the floor is finished
- Connect to the boiler, commission and balance
Recent work
Underfloor Heating near you
Choose your town for local arrival times, the homes we see there and recent jobs.
- Benfleet
- Basildon
- Canvey Island
- Corringham
- Hadleigh
- Rayleigh
- Stanford-le-Hope
- Wickford
- Billericay
- Hockley
- Leigh-on-Sea
- South Woodham Ferrers
- Aveley
- Brentwood
- Chelmsford
- Grays
- Rochford
- South Ockendon
- Southend-on-Sea
- Tilbury
- Maldon
- Purfleet-on-Thames
- Witham
- Burnham-on-Crouch
- Chipping Ongar
- Braintree
- Great Dunmow
- Waltham Abbey
- Chigwell
- Epping
- Harlow
- Loughton
- Buckhurst Hill
- Colchester
- Halstead
- West Mersea
- Wivenhoe
- Manningtree
- Brightlingsea
- Clacton-on-Sea
What customers say
Matt HarringtonGoogle review★★★★★I called Essex Heating Engineers after I bled my radiators and then the heating would no longer come on. I hadn’t used them before and found them on google. From the moment I called they were great - it’s peak season but they found time to come and diagnose...
Grace MacdonaldGoogle review★★★★★We noticed our boiler was leaking late at night and contacted these guys, they turned up the very next morning. Liam fixed it temporarily to keep us going while waiting for a new part, then Ash came back two days later and sorted it properly. Fantastic serv...
Natalie CatinoGoogle review★★★★★I first used Essex Heating Engineers as an emergency call out on a Sunday for my children’s nursery. They came out within the hour and dealt with the issue immediately. They then followed up the next day to do some further investigation as to why the boiler...
Questions about underfloor heating
How much does underfloor heating cost?
It depends on the floor area, the floor construction, the number of zones and whether the boiler needs upgrading, so we quote after a free survey. Fitting it into a new extension while the floor is open is the most economical time, and retrofitting into an existing floor with an overlay system costs more.
How quickly can you install it?
Underfloor heating is planned around your build. Call 01268 855605 early, ideally before the floor is designed, and we will book the survey and fit the pipework at the right point in the schedule. The engineer will tell you how long the install takes for your floor when they have seen it.
Does underfloor heating work with a combi boiler?
Yes. The manifold has its own pump and mixing valve that blends the boiler flow down to the lower temperature the floor needs. We check the combi has enough output for the floor and the radiators together, and set the controls so the two zones can run independently.
Which floors can it go under?
Screed floors in new extensions take pipe clipped to insulation before the screed is poured. Existing solid floors can take a low-profile overlay board. Timber floors can have pipe laid between the joists with spreader plates. Tile and stone conduct heat best, engineered wood works well, and thick carpet with underlay holds the heat back.
Can I have underfloor heating downstairs and radiators upstairs?
Yes, that is the most common layout. The underfloor heating runs as its own zone through the manifold and the radiators run as another, each with its own thermostat. The boiler serves both and the controls decide which is calling for heat.
Does hard water affect underfloor heating?
The underfloor loops are a sealed circuit filled once with treated water, so scale is not the problem it is for a combi's hot water side. Hard water does affect the boiler feeding the system, and Essex water averages around 317 ppm, so we still recommend scale protection on the mains supply.

