A full central heating installation in Vange starts with a heat loss survey, the same as anywhere in the Basildon area. What we build in for Vange is protection against hard water (263 ppm) and, for the 82% of homes on mains gas, a boiler sized to the house rather than the brochure. We are about 5 minutes away.
A full central heating installation means a new boiler, radiators, pipework and controls designed together for the house, rather than a boiler bolted onto whatever was there before. It is the right job for a home with no gas central heating, a system that has reached the end of its life, or an extension and refurbishment that changes how the house is heated.
We start with a room-by-room heat loss calculation, size each radiator to its room, plan the pipe routes, and specify the boiler, cylinder if needed and controls to match. You get a written quote for the whole job. On site the pipework and radiators go in first, then the boiler, then the system is flushed, dosed with inhibitor, commissioned and balanced so every radiator heats evenly.
Essex Heating Engineers has designed and installed heating systems across the county for more than 40 years. We are Gas Safe registered (925538), a Baxi Approved Installer and also fit Worcester Bosch, Vaillant, Ideal and Glow-worm. Every installation is notified under the Building Regulations and the boiler warranty is registered for you.
- Drive from base
- 2.4 miabout 5 minutes
- Homes on mains gas
- 82%2021 Census
- Water hardness
- 263 ppmHard water
- Central Heating Installation
- Free surveyPrice agreed first
Central Heating Installation in Vange: the local picture
82% of the 4,009 households around Vange heat with mains gas only, 6% are electric only (2021 Census, ward level).
Water in the Vange area is hard at around 263 ppm, so limescale in boilers, cylinders and showers is a common cause of faults here.
Vange is 2.4 miles from our base in Bowers Gifford, about 5 minutes by van.
What is included
- Room-by-room heat loss calculation
- Radiator sizing and positioning
- Boiler, cylinder and controls specified for the house
- All pipework, valves and fittings
- Programmer, room thermostat or smart thermostat and TRVs
- Flushing, inhibitor and magnetic filter
- Commissioning, balancing and Building Regulations certificate
- Manufacturer warranty registration
How it works
- Survey the house and calculate the heat loss
- Design the system and quote in writing
- Install pipework and radiators first, then the boiler
- Commission, balance and test every radiator
- Register the warranty and hand over the paperwork
Recent work
What Vange customers say
Joshua FoxGoogle review★★★★★Essex Heating Engineers installed a new boiler for me in Rayleigh, and they were excellent from start to finish. The team was punctual, tidy, and really professional. The installation was quick, everything was explained clearly, and the new boiler works per...
Darren DeaconGoogle review★★★★★Ash arrived on time, gave us his advice and explained how we should proceed. His quote was reasonable and when we get his email we will arrange a time for the installation of a new thermostat. They covered our floors, so they didn't track anything in. They ...
Jack CoreyGoogle review★★★★★Essex Heating Engineers is my go-to company. They always do a great job. Dean was especially knowledgeable, efficient and dedicated. Getting my house back in working order after a leak in the upstairs bath was problematical, to say the least. But Dean did w...
Questions about central heating installation in Vange
How much does a new central heating system cost?
It depends on the size of the house, the number of radiators, whether a cylinder is needed and how much pipework has to be run, so we quote after a free survey. The boiler element starts from £1,980 fitted and the rest is itemised in the written quote so you can see where the money goes.
How quickly can you install it?
Call 01268 855605 and we will book the survey at a time that suits you. The installation date is agreed when you accept the quote, and the engineer will tell you how many days the job will take for your house when they have seen it.
How disruptive is a full installation?
Pipework has to run under floors and through walls, so carpets and floorboards are lifted in the rooms the pipes pass through and put back afterwards. We plan the routes to keep this to a minimum and tell you before we start which rooms are affected on which days.
Do I need a hot water cylinder?
Not always. A combi boiler heats water on demand and suits homes with one bathroom and reasonable mains pressure. Homes with two or more bathrooms in use at the same time usually do better with a system boiler and a cylinder. The survey looks at your water pressure and how many people use hot water at once.
How far is Vange from you?
Vange is 2.4 miles from our base in Bowers Gifford, about 5 minutes by van. Same-day emergency cover and typical arrival in about 5 minutes.
Other services in Vange
- Boiler Installation and Replacement
- Central Heating Repairs
- Radiators and Radiator Valves
- Smart Thermostats and Heating Controls
- Hot Water Cylinders and Tanks
- Underfloor Heating
- All services in Vange
Central Heating Installation near Vange
See the full Central Heating Installation page for everything we cover across Essex.
