Dovercourt is about 65 minutes from our base, and we have fitted underfloor heating in extensions across the Tendring area. Most run from a combi or system boiler, which suits an area where 81% of homes are on mains gas. Because the water is hard at around 288 ppm, the boiler side gets the same protection we recommend on any new system.
Wet underfloor heating runs warm water from your boiler through pipe loops under the floor, turning the whole floor into a low-temperature radiator. It suits kitchens, extensions, bathrooms and open-plan ground floors where wall space is short, and it works with a gas combi or system boiler through a mixing valve and manifold.
We design the pipe loops for each room from its heat loss, install the manifold, pump and mixing valve, lay the pipe in screed, on an overlay board or between joists depending on the floor, pressure test it before the floor goes down, connect it to the boiler and commission and balance each loop. Room thermostats and zone controls let you run it separately from the radiators upstairs.
We have installed underfloor heating across Essex alongside the boilers and radiators it connects to, so the whole system is designed by one firm. Gas Safe registered (925538), family run, and quoted after a free survey.
- Drive from base
- 55.1 miabout 65 minutes
- Homes on mains gas
- 81%2021 Census
- Water hardness
- 288 ppmHard water
- Underfloor Heating
- Free surveyPrice agreed first
Underfloor Heating in Dovercourt: the local picture
81% of the 7,042 households around Dovercourt heat with mains gas only, 7% are electric only (2021 Census, ward level).
Water in the Dovercourt area is hard at around 288 ppm, so limescale in boilers, cylinders and showers is a common cause of faults here.
Dovercourt is 55.1 miles from our base in Bowers Gifford, about 65 minutes by van.
What is included
- Design of pipe loops for each room
- Manifold, pump and mixing valve
- Connection to your existing or new boiler
- Zone controls and room thermostats
- Screed, overlay or joisted floor systems
- Pressure testing before the floor goes down
- Commissioning and balancing of each loop
- Advice on floor coverings and insulation
How it works
- Survey the rooms, floor build-up and boiler
- Design the loops and zones and quote in writing
- Install the manifold and lay the pipework
- Pressure test before the floor is finished
- Connect to the boiler, commission and balance
Recent work
What Dovercourt customers say
Joshua FoxGoogle review★★★★★Essex Heating Engineers installed a new boiler for me in Rayleigh, and they were excellent from start to finish. The team was punctual, tidy, and really professional. The installation was quick, everything was explained clearly, and the new boiler works per...
Darren DeaconGoogle review★★★★★Ash arrived on time, gave us his advice and explained how we should proceed. His quote was reasonable and when we get his email we will arrange a time for the installation of a new thermostat. They covered our floors, so they didn't track anything in. They ...
Jack CoreyGoogle review★★★★★Essex Heating Engineers is my go-to company. They always do a great job. Dean was especially knowledgeable, efficient and dedicated. Getting my house back in working order after a leak in the upstairs bath was problematical, to say the least. But Dean did w...
Questions about underfloor heating in Dovercourt
How much does underfloor heating cost?
It depends on the floor area, the floor construction, the number of zones and whether the boiler needs upgrading, so we quote after a free survey. Fitting it into a new extension while the floor is open is the most economical time, and retrofitting into an existing floor with an overlay system costs more.
How quickly can you install it?
Underfloor heating is planned around your build. Call 01268 855605 early, ideally before the floor is designed, and we will book the survey and fit the pipework at the right point in the schedule. The engineer will tell you how long the install takes for your floor when they have seen it.
Does underfloor heating work with a combi boiler?
Yes. The manifold has its own pump and mixing valve that blends the boiler flow down to the lower temperature the floor needs. We check the combi has enough output for the floor and the radiators together, and set the controls so the two zones can run independently.
Which floors can it go under?
Screed floors in new extensions take pipe clipped to insulation before the screed is poured. Existing solid floors can take a low-profile overlay board. Timber floors can have pipe laid between the joists with spreader plates. Tile and stone conduct heat best, engineered wood works well, and thick carpet with underlay holds the heat back.
How far is Dovercourt from you?
Dovercourt is 55.1 miles from our base in Bowers Gifford, about 65 minutes by van. Installations, servicing, landlord certificates and planned work. Typical drive time about 65 minutes, so we book these in advance.
Other services in Dovercourt
- Boiler Installation and Replacement
- Central Heating Installation
- Central Heating Repairs
- Radiators and Radiator Valves
- Smart Thermostats and Heating Controls
- Hot Water Cylinders and Tanks
- All services in Dovercourt
Underfloor Heating near Dovercourt
See the full Underfloor Heating page for everything we cover across Essex.
